Technical data

Removing Memory Modules
Removing Memory Modules
The memory modules can be removed from the Model 76 system
board and installed into the VAXstation 4000 system.
Memory
Configurations
Memory board allocation on the system board is divided into
three banks. The first two sockets (closest to the front of the
system) represent bank number one. The next two sockets
represent bank number two, and the last two sockets are bank
number three.
Caution:
Antistatic precautions must be adhered to when handling
memory boards.
Remove the
Modules
When removing modules, remove the rear-most module first
(bank number three) and work towards the front of the memory
stack.
To remove the memory modules from the Model 76 system, do
the following and refer to Figure 4–4:
1. Release the metal clips at each end of the memory module
and tilt the module back at an angle.
Removing Options from a Model 76 Workstation 4–7