Technical data

Removing the Ethernet ROM
Figure 4–5 Scanline Coprocessor Mounting Brackets
Post-Lock
Holes
Screws (3)
System
Module
Lift here
for removal
MLO-010912
2. Remove the scanline coprocessor from the four post locks by
pulling back the post lock tabs.
Caution:
Do not grasp the scanline coprocessor module by the
corners when you are lifting it up to remove it from the
system board. The timing buffer chip located underneath
the scanline coprocessor module can become easily
damaged by any pressure exerted on it.
3. Grasp the center of the scanline coprocessor module next to
the two connectors, and lift it up and off the system board.
4. Set the scanline coprocessor on an antistatic mat. Replace
this module after removing the Ethernet ROM.
4–10 Removing Options from a Model 76 Workstation