Technical data

4.4.9 ScanProc Graphics Module
The following hints provide removal and replacement assistance:
Hint Procedure
SPXg Removal
1 Remove the frame buffer/graphics subsystem processor (GSP) assembly.
SPXg Replacement
1 If the new FRU is a SIMM memory module, install it on the frame buffer
module.
2 Set the switch 2 setting toward the B marker on the frame buffer module for
a 66 Hz refresh rate.
Set the switch 2 away from the B marker on the frame buffer module for a
72 Hz refresh rate.
Switch 1 can be in either position (inactive).
3 Replace the RFI gasket.
4 Replace the GSP module.
Note: The GSP module and frame buffer module are replaced separately.
5 Make sure the two slots in the metal bracket on the graphics module line
up with the two notches on the plastic bracket along the rear of the system
module.
6 Press down firmly on module until it secures within the two front latches.
7 Check to see if the front edge of the metal bracket locks behind the ridge on
the plastic bracket described in Hint 5.
8 Replace the frame buffer module.
FRU Removal and Replacement Hints 4–11