Technical data

Hint Procedure
SPXgt Removal
1 Remove the plastic clip that holds the GSP module to the frame buffer
module.
Note: Attempting to remove both the GSP module and the frame buffer
module, by grasping the frame buffer module tail, could result in damage to
the module.
2 Lift the frame buffer tail bracket just enough to free it from the ridge on the
disk drive H-bracket.
3 Hold the frame buffer module above the GSP inter-module connectors.
The GSP module will remain connected to the system module.
Gently work the frame buffer module loose from the GSP inter-module
connectors.
4 Pull the frame buffer free from the RFI gasket.
5 Release the board latches and lift the GSP module from the system module.
SPXgt Replacement
1 Install RFI gasket.
2 Replace the GSP module.
Note: The GSP module and frame buffer module are replaced separately.
3 Make sure the two slots in the metal bracket on the graphics module line
up with the two notches on the plastic bracket along the rear of the system
module.
4 Press down firmly on the module until it secures within the two front
latches.
5 Check to see if the front edge of the metal bracket locks behind the ridge on
the plastic bracket described in Hint 3.
6 Replace the frame buffer module.
Snap the frame buffer module tail bracket over the ridge on the disk drive
H-bracket.
4–12 FRU Removal and Replacement Hints