Technical data

3.1.2 SET and SHOW Commands
The VAXstation 4000 Model 60 and VLC SET and SHOW commands are used
to set and examine system parameters. Table 3–1 provides a description of the
parameters for the SET and SHOW commands.
Table 3–1 SET/SHOW Parameters
Parameter Meaning SET SHOW
BFLG Default bootflag X X
BOOT Default boot device X X
CONFIG System configuration X
DEVICE Ethernet and SCSI devices
information
X
DIAGENV Diagnostic environment; must
have loopback connector installed
and mode set to 2 or 3
X X
ETHER Ethernet hardware address X
ERROR Errors from the last system or
self-test
X
ESTAT (Model 60 only) Status from the last system test X
FBOOT Power-up memory test flag X X
HALT Halt recovery action X X
KBD Keyboard language X X
MEM Memory address range X
MOP MOP listener X X
PSE Password enable X X
PSWD Password X
SCSI System SCSI ID X X
TRIGGER Enable network console X X
Using the Console 3–3