Technical data

3.1.2.8 ESTAT
The ESTAT parameter displays status information about the system test.
The SET command does not apply.
The following is an example of the SHOW ESTAT command:
Command Result
SHOW ESTAT Displays the summary from the most recent system test since
power-up. The display prompts for each summary screen.
3.1.2.9 ETHER
The ETHER parameter displays the Ethernet hardware address.
The SET command does not apply.
The following is an example of the SHOW ETHER command:
Command Result
SHOW ETHER ETHERNET = 08-00-2B-1B-48-E3
3.1.2.10 FBOOT
The FBOOT (fast boot) parameter determines whether the memory is tested
when power is turned on.
• The test time is reduced when main memory is not tested.
• The setting only affects the power-up test.
If FBOOT is equal to... Then the memory is...
0 Tested during power-up
1 Not tested during power-up
Note: FBOOT should only be set to 1 when troubleshoot-
ing requires a number of power cycles, and memory is not
the suspected fault.
The following is an example of the SET FBOOT and SHOW FBOOT commands.
Command Result
SET FBOOT 1 FBOOT = 1
Using the Console 3–7