Technical data

3.1.2.15 PSE and PSWD
The PSE parameter is the enable console password bit. When enabled, the
console password is required to access the console.
The PSWD parameter is used to set the console password. The SHOW
command does not apply.
The following are key points to remember about passwords:
If the PSE is equal to... Then the password feature is...
1 Enabled
0 Disabled
The following table describes the SET PSWD and SET PSE commands:
Command Result Description
SET PSWD PSDW0>>> xxxxxxxxxxxxxxxx
PSWD1>>> 1234567890ABCDEF
PSWD2>>> 1234567890ABCDEF
Old Password - only if a password has
been previously set
New password
Verify new password
>>> SET PSE 1 PSE = 1
How to Clear the Password
If you forget the password or need to clear the password, follow these
procedures:
Step Procedure
1 Turn the system power off.
2 Locate the two solder triangles near the TOY chip (alarm clock is painted on
the chip). Using a screwdriver, briefly ground the two triangles together.
3–10 Using the Console