User guide

MR-1000 user guide V1.3
17
In “Configure” selection, change IP address if necessary. After that press “Apply”.
NOTE! Remember change network adapter IP address to same subnet as RS/ETH Link. After
that, renew the login with implemented IP address.
FOR EVERY PERMANENT CONFIGURATION SAVE:
Remember press “Save configuration” in status view. DNP3 polling is enabled in picture 8.
10.9. Serial port settings
To change Serial port settings press “Configure  Serial port”. Select correct port which
settings you want to change. Port S01 – S06 meanings are mentioned in picture 9.
Picture 8
Picture 9