User manual

Blackfin DEV-BF548-Lite. DEV-BF548DA-lite Hardware User Manual

4.6 X1, X2, X3 Expansion Connectors

The Expansion Connectors on the DEV-BF548-Lite for a Stacked Height of 16mm are of the following

type:

Part Manufacturer Manufacturer Part Nr.

X1, X2 AMP (Stacked Height = 16mm) 5-5179010-2

Matching connector AMP 5179031-2

X3 AMP (Stacked Height = 16mm) 5-5179010-3

Matching connector AMP 5179031-3

Table 4-4: DEV-board connector types

The matching connector, which is used for building an extender board, can be ordered from

Bluetechnix.

4.7 X8, X10 – CAN1, CAN0 Connector

Pin No. Signal (Core Module) IO-Type

1 CAN+ I/O

2 CAN- I/O

Table 4-5: CAN Connector

4.8 X5 – Power Connector

The board is shipped with a 12V, 2A external DC/DC Power Supply which should be used.

Pin No. Signal Description

1 Vin (+6V to +16V DC) Input Supply Preferable 12V DC (2A)

2 NC

3 GND

Table 4-6: Power Supply

Figure 4-1: Power connector

To connect to X141 use a “DCPP1” e.g. from Cliff Electronic Components (2.1mm * 5.5mm * 9.5mm) plug

to the power supply. Outer contact is GND, inner contact is VCC.