Installation guide

Digital Monitoring Products, Inc. 1912XR Programming
Page 33
15-SET ACCESS CODE
15.1 SET ACCESS CODE - Pressing COMMAND at the Stop prompt displays SET
ACCESS CODE. This allows you to program a code that will then be required to
gain access to the panel's internal Programmer through the keypad. You can
change this code at any time to any combination of numbers from 1 to 5 digits
long.
Once you have changed the code, it is important that you write it down
somewhere and store it in a safe place. Lost access codes require the panel to
be sent back to DMP for repair.
Access Code restrictions
Do not set an Access Code higher than 65,535. Do not use the codes 6653,
2313, or any 3-digit code that begins with 98. All of these codes are reserved by
the 1912XR panel for various functions.
SET ACCESS CODE