User`s guide

Using an Existing Account File as a Template
If you want to create a new account by using an existing
account file as a template, open the Panel Information
window by selecting File > Panel Information. Select the
account file that you wish to use as a template by clicking on
that file in the list, then click on the Copy button at the
bottom of the window to open the Copy Panel window. This
copies all of the programming information from the source
account to the new account. The name and address
information is not copied.
Source : This field shows the account name and number that you are using as a template.
Version : Enter the firmware version number of the panel.
Receiver : Leave the Receiver field set to 1 unless you have multiple receivers.
Account : Enter the account number that you wish to assign to this subscriber account.
Take note of the account number guidelines discussed in the section Setting up New Alarm
Accounts on page
27.
When you have filled in all of the fields in the Copy Panel window, click on the OK button
to go back to the Panel Information window. From the list on the left side of the
window, select the line with the new account number you just created by clicking once.
Fill in the fields on the right side of the Panel Information window according to the
directions in the section Setting up New Alarm Accounts beginning on page
27.
System Link User’s Guide
32