User's Manual

XT30/XT50 Installation Guide Digital Monitoring Products
13
InstallatIon
Telephone RJ Connector
13.1 Description
ConnectthepaneltothepublictelephonenetworkbyinstallingaDMP356RJCablebetweenthepanel’sJ3
connectorandtheRJ31XorRJ38Xphonejack.
AtwopinheaderlabeledRJSUP(J7)isprovidedtoallowmonitoringofthetelephonecableconnected
betweenthepanelandaRJ38Xjack(pins2and7jumpered).AttachaDMPModel306HarnessbetweenJ7
andanyavailablezone.TheJ7pinsareconnectedviathetelephonecabletotheRJ38Xjackpins2and7.
TheRJ38Xjackprovidesajumperbetweenpins2and7whichcompletesthecircuit.Programthezoneasa
Supervisorytype(SV).Whenthetelephonecableisremoved,thekeypaddisplayszonetroubleandproduces
a steady tone.
To Telephone
Line
RJ31X or RJ38X
Phone Block
8
7
6
54
3
2
1
Ring Tip
To Premise
Phone(s)
Ring1
Tip 1
Figure 7: Phone Jack Wiring
13.2 FCC Registration
The panel complies with FCC part 68 and is registered with the FCC.
Registrationnumber:CCKAL00BXT50
RingerEquivalence:0.0B
13.3 Notication
Registered terminal equipment must not be repaired by the user. In case of trouble, the device must be
immediatelyunpluggedfromthetelephonejack.Thefactorywarrantyprovidesforrepairs.Registered
terminalequipmentmaynotbeusedonpartylinesorinconnectionwithcointelephones.Noticationmust
be given to the telephone company with the following information:
   a.Theparticularline(s)theserviceisconnectedto
b. The FCC registration number
c. The ringer equivalence
   d.Themake,model,andserialnumberofthedevice