User's Manual

XT30/XT50 Installation Guide Digital Monitoring Products
15
InstallatIon
Cellular Connections
17.1 Cellular
TheXT30/XT50Cellularoptionisavailablebuilt-inatthefactoryorasanoptionaladd-onmodule,Model
263G.TheJ19SMAcellularantennaconnectorisprovidedforthebuilt-incellularversionandprotrudes
through the top of the enclosure.
Ifthepanelisnotpurchasedwithbuilt-incellular,thentheJ24headerisprovidedtoconnecta263GDigital
CellularCommunicatorasanadd-on.The263GDigitalCellularCommunicatorprovidesacellularantenna
connectionthatprotrudesthroughthetopoftheenclosuresimilartoJ19.
Figure 10: Cellular and 1100 Series Wireless Antenna Connections
On-Board 1100 Series Wireless Antenna Connections
18.1 Wireless Antenna
TheXT50WirelessAntennaterminalblockJ20islocatedatthetoprightcornerofthecircuitboard.The
antenna installs through a small opening in the top of the enclosure and is attached to the panel using the
right terminal. The left terminal is not used.
TheXT50built-inwirelessoperateswithDMP1100Seriestransmitters.Seesection3.4foralistofaccessory
devices.
18.2 LED Operation
TwoLEDsdisplayreceiveroperationandactivity.Refertothetablebelowasrequired.
Operation
GreenLED-Flashestoindicatedataisbeingtransmittedfromthereceiver.
YellowLED-Flashestoindicatedataisbeingreceivedfromatransmitter.
Outputs
J11
1
2
3
4
J1
Ethernet
J16
Reset
J20
1100 Series
Wireless
Antenna
connection
J24 Celllular
header for
263G
connection
J19 Celllular
Antenna
connector
65555
Built-in Cellular
Module
Connect
antenna to
rightside
only
J18
Load
RED
Programming
J8
1100 Series
Antenna
(XT50)
Model 383
supplied
with panel