User's Manual

LT-0703 (4/06) © 2006 Digital Monitoring Products, Inc.
800-641-4282
www.dmp.com
Made in the USA
INTRUSION • FIRE • ACCESS • NETWORKS
2500 North Pa rt ne rs hi p Bo ul ev ar d
Springfield, Missouri 65803-8877
Installing or Replacing the Battery
Observe polarity when installing the battery. Use only 3.0V coin cell
batteries, DMP Model CR2032, or the equivalent battery from a local retail
outlet.
Note: When setting up a wireless system, it is recommended to program
zones or devices and connect the receiver before installing batteries in the
transmitters.
1. Insert a small at head screwdriver into the slot at the keyfob end
opposite the keyring and twist to separate the keyfob front and back
sections.
2. If replacing the battery, push and slide the old battery out of the
holder in the direction of the arrow to remove it. See Figure 3.
3. Slide the new 3.0V Lithium battery into the holder and push into place.
4. Snap the front and back sections back together.
Caution: Properly dispose of unused batteries. Do not recharge,
disassemble, heat above 212°F (100°C), or incinerate. Risk of re,
explosion, and burns.
Battery Life Expectancy
Typical battery life expectancy for DMP Model 1140 Series Keyfob is 2
years. DMP wireless equipment uses two-way communication to extend
battery life.
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modications made by the user and not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Keyfob
Back
Battery
Inside Battery
Compartmen
t
Keyfob Front
Slot
Push Battery
Edge to Slide
Battery Out
Figure 3: 1145 Battery Location
Specications
Battery
Life Expectancy 2 years
Type 3.0V Lithium CR2032
See Battery Life Expectancy for full details.
Dimensions 1.98” H x 1.98” W x 0.6” D
Color Black
Housing Material Flame retardant ABS
Patents
Patent(s) Pending
Listings and Approvals
FCC Part 15 Registration ID CCKPC0098