User's Manual
Table Of Contents
- Models 7860, 7863, 7870, 7873
- Touch Screen LCD Keypads
- DMP Keypad Features
- Touchscreen Display
- Micro SD Card
- Select Areas
- Installing the Keypad
- Harness Wiring
- Additional Power Supply
- Card Readers
- Door Strike Relay Specifications
- Zone 2 Door Contact with Soft-Shunt™
- Zone 3 Request to Exit
- Keypad Backlighting
- AC Power/Armed LED Operation
- Panic Icons
- Internal Speaker Operation
- End-User Options
- Keypad Options Menu
- Additional Programming
- User’s Guide
- Keypad Arming and Disarming
- Keypad Door Strike
- Keypad Entry Delay
- FCC Information
- Wiring Specifications for Keypad Bus
- Keypad Specifications
- Specifications
- Compatibility
- Listings and Approvals
- Accessories
12 7800 Series Keypad Installation Guide
PRELIMINARY
Site COde
pOSitiOn: 1
Site Code Position (7863, 7873 only)
Enter the site code start position in the data string. Touch
the display to enter a number between 0-255. Default is 1.
Site COde
Length: 8
Site Code Length (7863, 7873 only)
Enter the number of characters the site code contains.
Touch
the display
to enter a number between 1-16. Default is 8.
USer COde
pOSitiOn: 9
User Code Position (7863, 7873 only)
Dene the User Code start bit position. Touch the display to
enter a number between 0-255. Default is 9.
USer COde
Length: 16
User Code Length (7863, 7873 only)
Dene the number of User Code bits. Touch the display to
enter a custom number. Custom numbers can only be a
number between 16-32. Press CMD to save the entry. The
default is the DMP value of 16.
reqUire Site
COde: nO yeS
Require Site Code (7863, 7873 only)
Touch YES to use a site code and press CMD to view the site
code entry display. Default is NO.
In addition to User Code verication, door access is only
granted when any one site code programmed at the SITE
CODES entry option matches the site code received in the
Wiegand string. You can program up to eight three-digit site
codes.
Note: A card with a site code greater than three digits
cannot be used. Use only cards with three-digit site codes.
Site COdeS 1-4
> > > >
Site Codes 1-4 (7863, 7873 only)
Enter site codes 1-4 (left to right separated by > sign). Touch
the > sign to add, delete, or change the site code and press
CMD. Site code range is 0-999. Press the CMD key to display
SITE CODES 5-8.
Site COdeS 5-8
> > > >
Site Codes 5-8 (7863, 7873 only)
Enter site codes 5-8 (left to right separated by > sign). Press
the Select key below the > sign to add, delete, or change the
site code and press COMMAND. Site code range is 0-999.
degraded MOde
reLay aLWayS OFF
Degraded Mode (7863, 7873 only)
This option denes the relay action when communication
with the panel has not occurred for ve seconds. Touch
the display to display CHOOSE ACTION. The default is Relay
Always Off.