User's Manual

Digital Monitoring Products 738Z Z-Wave Module Installation Guide
2
Programming the Panel
The 738Z Z-Wave module is programmed from the panel programming menu after the Device Setup menu. Refer
to the XT30/XT50 Series Programming Guide (LT-0981) or the XTL Programming Guide (LT-1108) for information on
programming the 738Z into the panel.
LED Operation
Two LEDs display receiver operation and activity. Refer to the table below as required.
Operation
PTX Green LED (Far left LED) - Flashes to indicate data is being sent to the panel.
ZTX Green LED (Middle LED) - Flashes to indicate data is being sent to the Z-Wave controller.
ZRX Yellow LED (Far right LED) - Flashes to indicate data is being received from the Z-Wave controller.
Device Compatibility
• Z-Wave Thermostat (DMP Model Z-TZEMT400BB3X)
• Z-Wave Light Control Module (DMP Model Z-45603)
• Z-Wave Light Control Module with Dimmer Switch (DMP Model Z-45602)
• Z-Wave Deadlock Door - Polished (DMP Model Z-99100-004)
• Z-Wave Deadlock Door - Satin (DMP Model Z-99100-005)
• Z-Wave Deadlock Door - Venetian (DMP Model Z-99100-006)
MyAccess™ LED Operation
The 738Z module can be controlled from a cell phone using MyAccess™ Text Messaging commands.
Action Text Command to send to panel
List loocks that are unlocked STATUS LOCKS
Lock a specic lock (enter name of lock) LOCK NAME
Unlock a specic lock (enter name of lock) UNLOCK NAME
List lights that are on STATUS LIGHTS
Turn on a specic light (enter name of light) TURN ON NAME
Set a specic dimmer to level xx (enter name of light
and dimmer level)
TURN ON NAME LEVEL
Turn off a specic light (enter name of light) TURN OFF NAME
List status of all thermostats (inclluding system
setting and temperature of room)
STATUS THERMOSTATS
Set the thermostat to Cool or Heat with this
temperature (enter name of thermostat and
temperature)
SET NAME COOL TEMP
SET NAME HEAT TEMP
Set the thermostat to Auto with heat and cool temps
(enter name of thermostat, auto and high and low
temperatures)
SET NAME AUTO HI LO
Set the thermostat to Auto with one temperature
(enter name of thermostat, auto and temperature)
SET NAME AUTO TEMP
Set the thermostat fan to Auto or On (enter name of
thermostat, fan and auto or on)
SET NAME FAN ON
SET NAME FAN AUTO
Set the thermostat to a specic temperature, but do
not change the current AUTO/COOL/HEAT setting
(enter name of thermostat and temperature)
SET NAME TEMP