Installation Guide

2 738ZPLUS INSTALLATION GUIDE | DIGITAL MONITORING PRODUCTS
4
ADD DEVICES
After wiring the 738Zplus to the panel, use a DMP keypad to program Z-Wave Plus devices into
the panel through the User Menu Z-Wave Setup option. This allows users to add devices through
the User Menu or the Virtual Keypad App™ after installation. When possible, have the Z-Wave
device near the 738Zplus during setup and programming.
Note: When programming Z-Wave devices into a XT50 or XTLplus panel, you can add
multiple devices at once. If you add multiple devices at once, then you will name each
device after they have all been added.
1. Open the Keypad menu, press CMD until MENU? YES NO appears, and then press YES.
2. After accessing the User Menu, press CMD until ZWAVE SETUP? appears. Press any select
key/area.
3. Select ADD. The screen displays PROCESSING.
4. When prompted, press the button (or series of buttons if adding a thermostat) on the
device you are adding.
5. The keypad displays that the device has connected to your system through the 738Zplus.
3
WIRE THE 738Zplus
The 738Zplus has four wire connections to connect to the panel’s keypad bus. See Figure 4.
1. Connecting the wires to the 738Zplus
terminals.
a. Connect the wire that delivers power
to the module to the RED terminal.
b. Connect the wire that sends data
from the module to the YEL terminal.
c. Connect the wire that receives data
from the panel to the GRN terminal.
d. Connect the ground wire to the BLK
terminal.
2. Carefully place the 738Zplus PCB back
into the housing, and then snap the
housing cover into place.
3. At the panel, connect the wires to the
keypad bus corresponding terminals.
Figure 4: 738Zplus Module PCB & Connections
Wiring to
Keypad Bus
ADDITIONAL INFORMATION
LED Operation
See Figure 4.
• PTX Green LED - If the light is blinking, then data is being sent to the panel.
• ZTX Green LED - If the light is blinking, then data is being sent to Z-Wave Plus devices.
• ZRX Yellow LED - If the light is blinking, then data is being received from Z-Wave Plus devices.
Z-Wave Certification
• The 738Zplus is a Z-Wave Security enabled device.
• The 738Zplus can be added to an existing network as a secondary controller by using the XFER (transfer) process and
selecting secondary from the primary controller.
Note: See the Z-Wave setup section of your control panel user guide for more information.
• The 738Zplus is compatible with Z-Wave Plus devices from all manufacturers.
• The 738Zplus can perform a factory default reset by initializing defaults in the panel programming menu.