Installation Guide TEST CEL CAN ER POW M COM E UBL TRO EM20 PERSONAL eMERGENCY rESPOnse system console
MODEL EM20 INSTALLATION GUIDE FCC NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Table of Contents Specifications 1.1 1.2 1.3 Power Supply...................................................................................................... 1 Communication.................................................................................................... 1 Enclosure Specifications....................................................................................... 1 Introduction 2.1 System Configurations...............................................................................
Installation Specifications 1.1 Power Supply Input: 16.5VAC Standby Battery: 12V Sealed Lead Acid 1.2 Communication EM20C Cellular Communicator The Cellular communicator uses DMP Model 264C CDMA to communicate with the Central Station receiver. EM20D Dialer Communicator The Dialer communicator uses digital dialer line to communicate with the Central Station receiver. 1.3 Enclosure Specifications The EM20 ships in a plastic enclosure with a Quick Start Guide (LT-1329) and User Guide (LT-1347).
Installation Installation 4.1 Location Information A location should be selected that is centrally located between the 1100 Series transmitters used in the installation. Place the EM20 away from metal objects. Placing the EM20 on or near metal surfaces impairs performance. Primary Power Supply 5.1 AC Power Supply 1. U npack the 16.5VAC power supply and fully unroll the cord. 2. Connect the power supply to the Red RJ22 connection on the back of the EM20. 3.
Installation Status Light Operation 7.1 Status Lights Each Status Light indicates the current status of the EM20 Console. Green POWER Light Off............ No AC Power. Check power cord is plugged in. Blinking....... AC Power Adapter is plugged in but the battery is low. On Steady ... AC Power and battery good. This is normal. Red COMM Light Off............ Normal Blinking....... No telephone line or cellular connection detected. On Steady ... Connected to an operator or sending a message.
Installation 10.1 Telephone Telephone Connections Connect the House Phone 1. Unpack the color-coded phone wire and fully unroll. 2. Connect the Green wire to the Green RJ11 Connector on the back of EM20. 3. Connect the opposite end of the Green wire to the house phone wall connection. ELECTRICAL Wall Jack Home Phone EM20D Console 16 VDC 16.5Vac Power Adapter TELEPHONE Wall Jack Figure 6: Telephone Connections. 10.2 Cellular Connect to Cellular Network 1.
COMPLIANCE EM20 Personal Emergency Response System Console Compliance Home Health Care Signaling Equipment ANSI/UL 1637/1635 11.1 Home Health Care Signaling Equipment 1. Power fail hours needs to be set to 8 hours or less in System Options. 2. Add the character “D” to the beginning of a phone number in Communications for the EM20 to wait for a dial tone before dialing. Patents U. S. Patent No.
