User's Manual

Digital Monitoring Products CellComSL Series Communicator Install/Programming Guide
16
COMMUNICATION
8.14 First IP Port
EntertherstIPportnumbertobeusedinconjunctionwiththeFirstIPAddress.TheIP
portidentiestheportusedtocommunicatemessagestoandfromthecommunicator.
ThedefaultIPPortsettingis2001.
8.15 Second IP Address
EnterthesecondIPaddresswherethecommunicator sendsnetworkmessages.TheIP
Addressmustbeuniqueandcannotbeduplicatedonthenetwork.Enterall12digitsand
leaveouttheperiods.Forexample,enterIPaddress192.168.0.250as192168000250.
The periods display automatically.
8.16 Second IP Port
EnterthesecondIPportnumbertobeusedinconjunctionwiththeSecondIPAddress.
TheIPportidentiestheportusedtocommunicatemessagestoandfromthe
communicator.ThedefaultIPPortsettingis2001.
8.17 Receiver 2 Programming
Allowsyoutosettheoptionsforthesecondreceiverthecommunicator attempts to
contact when sending reports. The communicator supports communication to two
receivers.IfyouselectYESforanyoftheReceiver2options,youmusthaveatleastone
IPaddressprogrammedinReceiver2programming.Receiver2defaultsaresettoNO.
8.18 Alarm Reports
YESenablesAbort,Alarm,AlarmRestoral,AlarmBellSilenced,Ambush,ExitError,and
SystemRecentlyArmedreportstobesenttothisreceiver.DefaultisNO.
8.19 Supervisory/Trouble Reports
YESenablesSupervisory,Trouble,TroubleRestoral,ForceArmed,LatetoClose,and
Faultreportstobesenttothisreceiver.DefaultisNO.
8.20 Opening/Closing and User Reports
YESenablesOpening/Closing,DoorAccess,ScheduleandCodeChanges,Bypass,and
SensorResetreportsbyusertobesenttothisreceiver.DefaultisNO.
8.21 Test Report
YESenablestheRecallTestreporttobesenttothisreceiver.DefaultisNO.
Messaging Setup
9.1 Messaging Setup
This section allows you to enter the information needed to send and receive messages
directlytoandfromthepanelviaE-MailandMyAccess™textmessagingusingCDMA
cellularcommunication.Allofthenameandpasswordoptionsbelowallowupto32
lowercasecharacterstobeentered.TheDestinationaddressesallowupto48characters
tobeentered.SystemNameisdisplayedwithinitialcaps.
The transmitted messages are:
•ZoneAlarmsbyZoneName
•ZoneTroublesbyZoneName
•ZoneBypassbyUser
•Arming(Closings)byUser
•Disarming(Openings)byUser
•LatetoClose
•LatetoOpen
•EarlytoClose
•ACPowerTroubleandRestoral
•SystemLowBattery
•Ambush
•Abort,CancelandAlarmVeriedbyUser
•Check-inbyUser
9.2 Enable Messaging
SelectYEStoallowthepaneltosendmessagestothreeprogrammeddestinations.
DefaultisNO.
FIRST IP PORT
2001
SECOND IP ADDR
000.000.000.000
SECOND IP PORT
2001
RECEIVER 2 PROG
ALARM NO YES
SPV/TRBL NO YES
O/C USER NO YES
TEST RPT NO YES
MESSAGING SETUP
MESSAGING SETUP
ENABLE MESSAGING
NO YES