User's Manual

Digital Monitoring Products CellComSL Series Universal Communicator Installation and Programming Guide
14
messagIng setup
Messaging Setup
8.1 Messaging Setup
This section allows you to enter the information needed to send and receive messages
directlytoandfromthepanelviaMyAccess™textmessagingusingCDMAcellular
communication.TheDestinationaddressesallowupto48characterstobeentered.
SystemNameisdisplayedwithinitialcaps.
The transmitted messages are:
• ZoneAlarmsbyZoneName
• ZoneTroublesbyZoneName
• ZoneBypassbyUser
• Arming(Closings)byUser
• Disarming(Openings)byUser
• ACPowerTroubleandRestoral
• SystemLowBattery
• CancelbyUser
8.2 Enable Messaging
SelectYEStoallowthepaneltosendmessagestothreeprogrammeddestinations.
DefaultisNO.
8.3 System Name
Enterauniq ue name for the communicator. The communicator name is used as the
sender of the message. The text entered is displayed w
ithinitialcaps.Ifthiseldisleft
blank,thecommunicatoraccountnumberissent.
8.4 Destination 1
Entertherstcellphonenumberwheremessageswillbesent.Themessagecanbesent
to any cell phone as long as a valid cell phone number is entered.
8.5 Destination 1 User Number
Enterauser’susernumberfromthisaccount.Thisoptionisusedwhensendingcommands
suchasarmingordisarmingbacktotheCellComSLusingMyAccess™textmessagingfrom
the same cell phone. The user number must have the authority to perform the commands.
Entering0(zero)disablesthisoption.Defaultis0.
8.6 Destination 2
Entertheseconddestinationcellphonenumber.
8.7 Destination 2 User Number
Entertheuser’sUserNumberforarming/disarmingauthorization.
8.8 Destination 3
Enterthethirddestinationcellphonenumber.
8.9 Destination 3 User Number
Entertheuser’sUserNumberforarming/disarmingauthorization.
8.10 O/C SMS
SelectYEStoallowthepaneltosendOpeningandClosingmessagestoacellphonevia
SMSprotocol.DefaultisNO.
8.11 Monthly Limit
ThisnumberlimitsthemonthlyincomingandoutgoingSMSmessagesallowedtobesent
or received by the communicator.
Apaneleventthatcausesmessagestobesenttodestinationcellphonenumbersis
countedtowardsthecommunicator’smonthlylimit.Forexample,SMSmessagessent
from a cell phone to the communicator including status requests and alarm messages
received from the communicator all count toward the monthly limit. The limit is reset
atmidnightonthe14thofeverymonth.Rangeisfrom0to999.When0isentered,
there is no limit on the number of messages able to be sent or received by the panel.
Defaultis0.
MESSAGING SETUP
DESTINATION 1
-
DESTINATION 2
-
DESTINATION 2
USER NUMBER: 0
DESTINATION 3
-
SYSTEM NAME
-
ENABLE MESSAGING
NO YES
DESTINATION 1
USER NUMBER: 0
O/C SMS NO YES
DESTINATION 3
USER NUMBER: 0
MONTHLY LIMIT: 0