User's Manual

CellComSL Series Universal Communicator Installation and Programming Guide Digital Monitoring Products
21
stop
Stop
15.1 Stop
AttheSTOPprompt,pressinganySelectkeyallowsyoutoexittheprogrammerfunction
of the communicator.Whenselected,thecommunicator performs an internal reset and
exits the programmer.
Set Lockout Code
16.1 Set Lockout Code
PressingCOMMANDattheStopoptiondisplaysSETLOCKOUTCODE.Thisfeature
allows you to program a special code that will then be required to gain access to the
communicator’sinternalProgrammerthroughthekeypad.
ChangingtheLockoutCode
Youcanchangethiscodeatanytimetoanycombinationofnumbersfrom1to5digits
long(1to65535).Donotuseleadingzerosforthelockoutcode.
1.PressanySelectkey.ThedisplaychangestoENTERCODE:-.
2.Entera1-to5-digitcode(donotenteranumberhigherthan65535).Press
COMMAND.
3.EnterthenewLockoutCodeagain.PressCOMMAND.Thekeypaddisplaychangesto
CODECHANGED.
Onceyouhavechangedthecode,itisimportantthatyouwriteitdownandstoreitin
asafeplace.LostlockoutcodesrequirethecommunicatortobesentbackintoDMP
forrepair.YoumaycancelaLockoutCodebyentering00000attheSetLockoutCode
command prompt.
LockoutCoderestriction:
DonotsetaLockoutCodehigherthan65535.
STOP
SET LOCKOUT CODE
set lockout code