User's Manual

Digital Monitoring Products CellComSL Series Universal Communicator Installation and Programming Guide
26
z-wave setup
17.13 Optimize (OPT)
SelectOptimize(OPT)toupdatecommunicationwithallZ-Wavedevices.Optimizecanbeusedtore-establish
communicationafteraZ-Wavedevicehasbeenmovedtoadifferentlocation.WhenOPTIMIZEisselected,
theCellCommakesthreeattemptstocommunicatewitheachZ-Wavedevice.Z-Wavedevicesthatfailto
communicate during the optimize process are not removed from CellCom programming.
1. AccesstheUserMenu.
2. Press COMMANDuntilZWAVESETUP?displays.
3. PressanySelectkey.ThekeypaddisplaysADDLISTREMOVE.
4. Press COMMANDagaintodisplayFAVXFEROPT.
5. SelectOPT,thekeypaddisplaysOPTIMIZEwhilethesystemissearchingforZ-Wavedevices.
6. ThekeypadwilldisplayOPTIMIZESUCCESSwhenZ-Wavedeviceshavebeenretrieved.
7. PressCOMMANDtoreturntoZWAVESETUP?.
Note:ThekeypadwilldisplayOPTIMIZEFAILEDwhencommunicationwithaZ-Wavedeviceisnotestablished.Press
COMMANDtoreturntoZWAVESETUP?andattemptoptimizeagain.IfcommunicationwithaZ-Wavedeviceisnot
re-establishedduringtheoptimizeprocess,makesurethedeviceispoweredon.Ifthedevicethatfailedhas
power, add a repeater between the CellCom and the device.