Programming Guide

1168 CO/Smoke Combo Unit Installation and Programming Guide 12
INSTALL THE BATTERY
The 1168 comes pre-installed with four 3.0V
lithium batteries. Firmly grasp the battery pull-tab
on the battery compartment and remove it. See
Figure4.
REPLACE THE COVER
After installing the battery, replace the cover back
on the base. Follow the directions below:
1. Place the detector on the base, aligning
the raised tab on the detector’s lip and the
cover latch on the base’s lip.
2. Rotate the detector until it clicks into
place.
3. Remove the orange plastic dust cover
from the detector once installation (and
any surrounding construction) is complete.
2
Figure 4: Battery Location
3