Programming Guide

1132 Installation and Programming Guide | Digital Monitoring Products 4
Mount the Transmitter and Magnet
1. To install the transmitter, use a 3/4 inch drill bit and drill a hole at least 2 3/4 inch deep in the frame at the
desired location.
Caution: Avoid drilling in areas where electrical wiring runs through the wall.
2. Insert the transmitter housing into the hole until the flange is flush with the door jamb.
3. To install the magnet, use a 3/4 inch drill bit, drill a hole at least 3/4 inch deep in the door edge at the
desired location.
4. Insert the magnet into the hole and press it into place.
3
Figure 2: Mounting the Transmitter and Magnet
0.75” DIA x 2.5” D
0.75” DIA x 0.63” D
TEST THE TRANSMITTER
After the transmitter has been installed, test to confirm that it is communicating reliably with the panel. Use the
Tech APP™ to perform a Wireless Check‑in Test on the system or complete the following steps to perform a Wireless
Check‑in Test from a keypad that is connected to the panel:
At the keypad, enter 8144 (WALK) and select WLS. If the transmitter fails to check in at the keypad, check for sources
of interference such as metal objects and electronic equipment.