User`s guide

24 XR150/XR350/XR550 User’s Guide User Menu
ZONE STATUS $OORZV\RXWRVHHLID]RQHLVHLWKHUDUPHG
bypassed, in alarm, open, or shorted.
BYPASS ZONES $OORZV \RX WR %\SDVV D ]RQH RU UHVHW DQ
DOUHDG\E\SDVVHG]RQH
ZONE MONITOR $OORZV\RXWRDGGRUUHPRYHD]RQHIURPWKH
monitor mode.
SYSTEM STATUS Displays the current condition of the system
AC power, backup battery, and optional
panel tamper.
SYSTEM TEST Tests the system siren, communication to
the central station, and backup battery on
all XR150, XR350, and XR550 Series panels.
XR550N or XR550E panels allow additional
SDQLF]RQHWHVWLQJ
USER PROFILES Allows you to add, delete, or change user
SURÀOHV
USER CODES Allows you to add, delete, or change user
codes.
EXTEND CLOSING Allows the Closing Check operation to delay
until the new closing time expires. This
allows the current schedule to ignore its
FORVLQJWLPHDQGQRWVHQGD/$7(72&/26(
message to the central station.
SCHEDULES Allows you to add, remove, or change
system schedules.
TIME Allows you to change the Day, Date, or Time
that is currently programmed in the system.
DISPLAY EVENTS Allows you to view or print the last 10,000
door accesses or 2,000 system events that
occurred on your system.
SERVICE REQUEST Allows you to send a message to the Central
Station requesting service on the alarm
system.
FIRE DRILL $OORZV\RXWRWHVWWKHV\VWHPÀUHEHOOV
Alarm Silence
Silences the alarm bells or sirens during an alarm.
Alarm Silence allows you to turn off the alarm bells and sirens
connected to your system during an alarm. Using Alarm Silence
GRHV 127 VWRS DQ DODUP UHSRUW IURP EHLQJ VHQW WR WKH FHQWUDO
station and does not reset any alarmed devices. Use the Sensor
Reset function to reset devices such as smoke detectors that have
latched in alarm.
Note:7KHNH\SDGWRQHVLOHQFHVDVVRRQDVWKHÀUVWXVHUFRGHGLJLW
key is pressed. You can silence the alarm by entering your user
code or by presenting your card to a reader during the Status List
display. If using a card, areas assigned to your code are disarmed
and door access occurs.
Using the Alarm Silence Function
1. Access the User Menu.
2. The keypad displays ALARM SILENCE?.
3. Press any Select key to silence the bells and exit the User
Menu.
Sensor Reset
Resets smoke or glassbreak detectors. Also clears Fire/Supervisory
alarm, trouble displays or low battery displays on systems using
wireless sensors.
Sensor Reset is used to reset smoke and glassbreak detectors after
WKH\KDYHWULSSHG2QFHWKHVHGHWHFWRUVWULSWKH\PXVWEHUHVHW
before they can detect any additional alarm conditions. When you
select Sensor Reset, power to the detectors is temporarily removed
by the system allowing them to reset.
Make sure all smoke is cleared from around the area of the smoke
detectors before performing a Sensor Reset to prevent the alarm
from occurring again.