User's Manual

-21-
7) East, West Limit
: Press E key on the RCU
continuously until your antenna
reaches to the easternmost point
and then press OK key on the RCU.
The message of “Would you like to
set East limit of DiSEqC motor?” will
be displayed for your confirmation.
Place cursor on the “OK” and press
OK key on the RCU to confirm the
East limit. Then, the value of East
Limit will be changed to be “set”.
To set West limit, take the same
steps as East limit.
8) Reset DiSEqC limit
: If you want to reset the East limit
or West limit, place the cursor on
ResetDiSEqCLimit button and then,
press OK key on the RCU. The
message of “Would you like to
reset limit for DiSEqC positioner?”
will be displayed for your confirma-
tion. Select OK button and press OK
key on the RCU.
The cursor will move to the East limit
button so that you can reset the limit.
After that, please reset West limit
same as before.
After setting all necessaries, please
EXIT to finish antenna setup menu.
The message of “Are you sure to
change the configuration of antenna
setup?” will be displayed. Please
select OK button on the screen and
then wait for saving data.
User Installation