User`s guide

Digital Rapids TouchStream
Page 9
The Trigger button will be gray (or inactive) if the TouchStream has never been
run before or if the project that was previously loaded when the TouchStream
software was shut down has been deleted. In that case you will need to set up a
new configuration.
Getting Started – Setting up a new configuration
If you are setting up the TouchStream software for the first time, or you want to
set up a new configuration, there are a few basic steps.
1. Press the Setup button.
The Setup screen will show the following buttons:
2. Press the Project Settings button. Choose the project that you want to use
from the panel on the right. Information about the project will be displayed on the
left. The default projects that are displayed in this list will vary, depending on the
TouchStream model that you have purchased.
3. Press the Input Settings button and select the video and audio inputs that you
want to use. The default input settings that are displayed in this list will vary,
depending on the capture board installed in your TouchStream model.
4. Press the Output button and choose whether you want to enable an Archive
output (to record to a file to an external drive) and/or to a Broadcast output. Note
that if you want to create a live stream only, then you will need to disable the
Archive output.
5. Optional: You can adjust the Video Settings and Audio Settings if desired,
checking the green Done button to return to the Setup screen each time.
6. Press the Trigger button to choose the method you plan to use to start and
stop the encoding. Press the Arm button to accept the trigger setting and put the
unit in a standby mode, or the Cancel button to return to the main Setup screen
without setting a trigger.