Operating instructions

Controls and operation G3 Series
Automatic tool initialisation
4-48
000010,06,02-2009, jmu
4
4.9 Automatic tool initialisation
Important !
Manual initialisation is described in the operating manual of the relevant tool. See
chapter "Tools".
4.9.1 Description
The following tools can be initialised using the automatic tool initialisation:
– Kiss cutting tool (without glide element) (KCT)
– Universal cutting tool (UCT)
– Electrically oscillating cutting tool (EOT)
– Pneumatically oscillating cutting tool (POT
– Driven rotary cutting tool (DRT)
–Router
Attention !
Danger of the cutter being damaged
Only use the automatic tool initialisation for compatible tools. Carry out manual
initialisation for other tools that are not listed.
Fig. 4-30 Automatic tool initialisation
1 Holder
2 Rest
3 Automatic tool initialisation