Operating instructions

G3 Series Controls and operation
Automatic tool initialisation
4-49
000010,06,02-2009, jmu
4
4.9.2 Setting the height
Important !
Ensure that the automatic tool initialisation lies planar on the cutting base (conveyor
belt). Adjust the height if necessary.
Fig. 4-31 Setting the height
⇨ Turn the adjusting screw anti-clockwise
⇨ Place the automatic tool initialisation on the cutting base
⇨ Use the adjusting screw to set the gradient so that the automatic tool initialisation
is in a plane position on the cutting base
1 Automatic tool initialisation
2 Cutting base
3 Table
4 Adjusting screw