Operating instructions

Introduction G3 Series
Points to note when reading this operating manual
1-4
000009,04,02-2009, jmu
1
1.3 Points to note when reading this operating manual
Text references
Chapter headings are numbered consecutively, with the first figure corresponding to
the chapter number. Where reference is made to sections outside the current
chapter, note the first figure and turn to the corresponding chapter, which contains
the cited section. See chapter 2-4 "Overview of the machine", for example, leads to
chapter 2 "Product description", which contains section 4 "Overview of the machine".
Sketches and schematic representations
These are provided for general information and do not necessarily correspond to the
latest version of the machine.
Dimensional information
Dimensional information is listed in the SI/US unit system according to the place of
installation.
1.4 Care of the documentation
Volume 1 "Instruction manual" must always be kept in close vicinity of the
workstation.
Volume 2 "Service manual" must be made available to maintenance and service
personnel when required.