Operating instructions

Description of menu G3 Series
Description of menu
5-4
000015,031,02-2009, jmu
5
1-1-1-1 Select tool
No help tex t is available for this parameter.
Assign the tool that is used in the module.
For the attachment/selection of a new tool see chapter "Controls and operation",
"Tool handling"
1-1-1-2 Initialisation
No help tex t is available for this menu.
Setting of the tool working height. Further tool-specific information relating to the
initialisation can be found in the operating manual of the respective tool type.
3081
1-1-1-2-1 Define Z init pos
Determining t he Z positio n as the initi alisation positi on for the current to ol
Determining the Z position as the initialisation position for the current tool
3067
1-1-1-2-2 Auto init
No help tex t availablePlease wait.
Automatic initialisation with AKI
⇨ Position auto init tool on the work surface
⇨ Start function. The selected tool moves via the initialisation tool and starts the
initialisation procedure
✓ The value that is determined is saved for the specific tool.
3082
1-1-1-2-3 Up Z pos
No help tex t is available for this parameter.
Value for setting the tool position when the tool is raised (procedure).
To increase cutter efficiency, this position should only be set as high as is necessary.
3083
1-1-1-2-4 Test cut
Cuts a square 2 0 mm x 20 mm.
Carry out a quadratic test cut (20 mm x 20 mm). The zero point of the square is the
lower right-hand corner. The test cut is carried out in the current tool position.
Procedure
⇨ Place the material to be processed on the working surface
⇨ Select the function
⇨ Switch on vacuum (VAC - 2)
⇨ Use the travel keys to position the tool over the current material to be processed.
Choose OK to confirm.
⇨ Check the test cut. If necessary, redefine the the zero point on the Z-axis or
correct it using the
Z Offset function
1-1-1-2-5 Z Offset
No help tex t is available for this parameter.
Value for adjusting the processing depth by ±1.5 mm
The Z offset function moves the
Down Z pos by the value that is entered.
3085
1-1-1-2-6 Init height
Define the height of the suc tion unit d uring processing
Define the height of the suction unit during processing
Procedure