Operating instructions

Description of menu G3 Series
Description of menu
5-6
000015,031,02-2009, jmu
5
1-1-1-3-1-6 Continuous Path
No help tex t is available for this parameter.Of fOn
Continuous path switched on
The speed is the same in all directions. The speed can be calculated using the setting
value from
Down X&Y 1-1-1-3-2-2.
Continuous path switched off
The speed is calculated from the set axis speed in X and Y direction.
3296
1-1-1-3-1-7 Start with man. Init
No help tex t is available for this parameter.Of fOn
Setting of whether the motor spindle is switched on or off during the manual
initialisation.
2253
1-1-1-3-1-8 Stop angle
If a change in direction larg er than the s et angle is dete rmined during movement then the speed is reduced to zero before movement is start ed in the new direct ion.
If a change in direction larger than the set angle is determined during movement then
the speed is reduced to zero before movement is started in the new direction.
Fig. 5-4 Stop angle
751
1-1-1-3-2 Speed settings
Setting of the movement speeds for the tool that is in use.
Setting of the movement speeds for the tool that is in use. The possible moving
speed is dependent on the knife/router/pen being used and on the material to be
processed
2036
1-1-1-3-2-1 Up X&Y
Moving spe ed in the directi ons X and Y when the tool is raised
Moving speed in the directions X and Y when the tool is raised
Adjusting value: 1 - 1,000 mm/s
2037
1-1-1-3-2-2 Down X&Y
Moving s peed in the directions X and Y when the tool is lowered
Moving speed in the directions X and Y when the tool is lowered
Adjusting value: 1 - 1,000 mm/s
813
1-1-1-3-2-3 Lift Z
No help tex t is available for this parameter.
Speed when raising the tool
814
04
A Processing direction I Stop angle
ß Direction change (angle)