Operating instructions

G3 Series Description of menu
Description of menu
5-7
000015,031,02-2009, jmu
5
1-1-1-3-2-4 Lower Z
No help text is available fo r this paramet er.
Speed when lowering the tool
1115
1-1-1-3-3 Acceleration settings
Setting of the tool acceleratio n.
Setting of the tool acceleration. The acceleration is dependent on the knife/router/
pen being used and on the material to be processed
2038
1-1-1-3-3-1 Up X&Y
Acceleration of the tool in t he X/Y direction when the tool is raised
Acceleration of the tool in the X/Y direction when the tool is raised
Setting range: 1 - 10 m/s
2
2039
1-1-1-3-3-2 Down X&Y
Acceleration of the tool in t he X/Y direction of the lowere d tool
Acceleration of the tool in the X/Y direction of the lowered tool
Setting range: 1 - 10 m/s
2
1973
1-1-1-3-3-3 Lift Z
No help text is available fo r this paramet er.
Acceleration of the Z axis when raising the tool
1974
1-1-1-3-3-4 Lower Z
This is the speed for the Z axis when it is moving from the up position to the down position.
Acceleration of the Z axis when lowering the tool
1811
1-1-1-3-4 Z axis settings
No help text is available fo r this menu.
Menu for setting the Z axis parameters.
1-1-1-3-4-5 Down Z pos
No help text is available fo r this paramet er.
Setting of the cutting depth/the tool position when the tool is lowered.
This position should only be set as deep as is necessary in order to avoid damage to
the cutting base.
2766
1-1-1-3-4-6 Max Z down
Maximum down position of the Z axis.
Limitation of the Down Z pos for the protection of the work surface. This value
specifies the maximum possible cutting depth. This setting is only valid for the
automatic initialisation.
2292
1-1-1-3-4-7 Pos / Pressure mode
No help text is available fo r this menu.
Menu for modules which can be used in both the position mode and the pressure
mode (e.g. universal module)
Position mode:
In the position mode, the cutting depth is defined using the zero point of the Z axis.
The module moves to the set zero point irrespective of the pressure/the cutting depth
Pressure mode:
The cutting depth is the result of a set pressure which is exerted on the tool by the
module.
The module moves into the material until the preset pressure is reached.
Initialisation generally takes place on the material surface. Then set the cutting depth
with the
Down Z pos function 1-1-1-3-4-2
2294
1-1-1-3-4-7-1 Pos / Pressure mode
Pressure or position mode?PositionPressure
Display of the current mode. Use the key to change to the selection menu and
select the required mode.