Operating instructions

Description of menu G3 Series
Description of menu
5-8
000015,031,02-2009, jmu
5
2888
1-1-1-3-4-7-2 X&Y pressure
No help tex t is available for this parameter.
Setting of the pressure in the X and Y direction.
Setting range: 2 - 20 kg
2295
1-1-1-3-4-7-3 X pressure
Separate settin g of the pressu re in the direc tion of the X ax is
Setting of the pressure for the X axis
Setting range: 2 - 20 kg
2296
1-1-1-3-4-7-4 Y pressure
Separate settin g of the pressu re in the direc tion of the Y ax is.
Setting of the pressure for the Y axis
Setting range: 2 - 20 kg
2699
1-1-1-3-4-8 Auto init options
Automatic knife initialisation
Menu for the determination of the zero point with the automatic knife initialisation.
For further information see chapter "Controls and operation" in the operating manual
Fig. 5-5 Init tool settings
2701
1-1-1-3-4-8-1 Init tool offset
Correctio n factor fo r setting the cut ting depth
Correction factor for setting the processing depth. This value can be used to adjust
the cutting depth by ±1.5 mm.
1774
1-1-1-3-4-9 Init Z pos
No help tex t is available for this parameter.
Z position after initialisation. This value is determined via the functions Define Z init
pos
1-1-1-2-1 or Auto init 1-1-1-2-2.
1816
1-1-1-3-5 T axis settings
No help tex t is available for this menu.
Settings of the T axis. E.g. universal module
1943
1-1-1-3-5-1 Auto lift-up angle
1 Zero point (light barrier height) 4 AKI2
2 Knife in operating position 5 Cutting base
3 Light barrier
b Init tool offset