Operating instructions

G3 Series Description of menu
Description of menu
5-9
000015,031,02-2009, jmu
5
Lift-up angle for the automat ic raising of the tool in a corner. If a dire ction change of more tha n the set value is detected dur ing the cutting process, the tool is raise d automaticall y, turned i nto the new cutting direction an d lowered again.
If a direction change of more than the set value is detected during processing, the
tool remains in position, is raised, turns into the new processing direction, is lowered
again and accelerates.
Fig. 5-6 Auto lift-up angle
2204
1-1-1-3-5-2 T axis rotation
Switching the tangential ro tation on and off.T axis offT axis on
Switching the tangential rotation on and off.
⇨ Switch the function for the rotation of the T axis off if it is not required for the
application (e.g. use of marking tools)
2711
1-1-1-3-5 Dust collector settings
No help text is available fo r this menu.
Setting of the parameters for modules with automatic dust collection
1-1-1-3-5-2 position
No help text is available fo r this paramet er.
Display of the current height of the suction unit
2719
1-1-1-3-5-3 Offset
No help text is available fo r this paramet er.
Correction value for the adjustment of the position of the suction unit during process-
ing
2720
1-1-1-3-5-4 Offset
No help text is available fo r this paramet er.OffOn
Switch Offset 1-1-1-3-5-3 on/off
1802
1-1-1-3-6 Tool delay settings
No help text is available fo r this menu.
Setting of the tool-specific delay times.
1859
1-1-1-3-6-1 Before down delay
Delay tim e in ms before th e module i s lowered.
Delay before lowering the tool
1860
1-1-1-3-6-2 After down delay
Delay time in ms after the module is lowered.
Delay after lowering the tool
1861
1-1-1-3-6-3 After down action delay
No help text is available fo r this paramet er.
A Processing direction W Movement angle
λ Auto lift-up angle A
n
Example: Movement angle
following change in direction