Operating instructions

Description of menu G3 Series
Description of menu
5-10
000015,031,02-2009, jmu
5
Delay time for tools which carry out an action after the lowering. E.g. passepartout
tool.
1862
1-1-1-3-6-4 After down delay
No help tex t is available for this parameter.
Delay before lifting the tool
1863
1-1-1-3-6-5 After up delay
No help tex t is available for this parameter.
Delay after lifting the tool
1864
1-1-1-3-6-6 Before up action delay
No help tex t is available for this parameter.
Delay time before lifting when the tool carries out an additional action. E.g.
passepartout tool.
3347
1-1-1-3-6-7 Up Impulse delay
No help tex t is available for this parameter.
Display of the delay before raising the tool (PUM)
3348
1-1-1-3-6-8 Up Impulse length
No help tex t is available for this parameter.
Display of the impulse duration for lifting the tool (PUM)
1887
1-1-1-4 Correction
No help tex t is available for this menu.
Description to follow
2336
1-1-1-4-1 Correction
Switching the knife connection accura cy on and off.Off
On
Activate/deactivate knife connection accuracy
1891
1-1-1-4-2 Correct X
Knife tip offset .
Correction value for the compensation of the tool tolerance/optimisation of the infeed
angle. Refer to
Test cut 1-1-1-4-4 for the determination of the correction value
1892
1-1-1-4-3 Correct Y
Knife tip offset .
Correction value for the compensation of the tool tolerance/optimisation of the infeed
angle. Refer to
Test cut 1-1-1-4-4 for the determination of the correction value
1899
1-1-1-4-4 Test cut
Automatic initialisation with AKIMove to a free point and press OK in order to sta rt the test cut.Test cut running...
Correction values, general
Important !
The penetration point and/or the cut direction of each test cut act as measuring points
for the calculation of the correction values. You should therefore observe exactly
where the blade penetrates when cutting the 4 lines and mark the penetration points.