Operating instructions

Description of menu G3 Series
Description of menu
5-12
000015,031,02-2009, jmu
5
Correct Y
When the axes are aligned, the cuts are moved towards the coordinate system axes
until each of the parallel cuts lie on the same axis.
Measure and calculate distance a (mm/in) of the parallel cuts to the X axis as follows:
⇨ Start the
Test cut 1-1-1-4-4 function
⇨ Enter the calculated value Y1 in the
Correct Y 1-1-1-4-3 field
⇨ Perform a test cut and recalculate the correction value if necessary
✓ The axes alignment process is complete when the cuts lie on the same line
(tolerance: ± 0.1 mm). Where necessary, check this using a magnifying glass.
Option 1: line 1 has to be moved to
the left and/or line 2 has to be moved
to the right to lie along the same line.
Y1=Y2-a/2
Option 2: line 1 has to be moved to
the right and/or line 2 has to be
moved to the left to lie along the
same line.
Y1=Y2+a/2
Result:
The cuts lie along one line
a...Distance in mm [in]
Y1...calculated value
Y2...current value from
Correct Y 1-1-1-4-3