Operating instructions

G3 Series Description of menu
Description of menu
5-39
000015,031,02-2009, jmu
5
5 Communication setup
Menu for the c ommunicatio n settings such as COM interf ace, parser etc.
Communications settings for parsers, interfaces,...
2279
5-2 Serial interface
No help text is available fo r this menu.
Communication settings for the serial interfaces
2280
5-2-1 COM 1
No help text is available fo r this menu.
Important !
If communications software (front end, terminal) is used, the communication settings
for COM 1 must match those for the communications software.
Communications settings for COM 1
2282
5-2-1-1 Baud rate
No help text is available fo r this paramet er.48009600
1440019200384005600057600115200
The baud rate defines the data transmission speed.
2283
5-2-1-2 Data bits
No help text is available fo r this paramet er.5678
Number of data bits during data transmission
2284
5-2-1-3 Stop bits
No help text is available fo r this paramet er.12
Define the number of stop bits. Stop bits signal the end of a data word.
The choices are:
•1
•2
2285
5-2-1-4 Parity
No help text is available fo r this paramet er.NoneUnevenEven
Define parity type. Parity is used to detect erroneous transfers.
The choices are:
•None
• Uneven
• Even
2286
5-2-1-5 Protocol
No help text is available fo r this paramet er.HardwareSoftwareNone
Define protocol transfer.
The choices are:
• Hardware
•Software
•None
With "none", data may be lost!
2281
5-2-2 COM 2
No help text is available fo r this menu.
Communication settings for COM 2. The settings must match the software.
5-3 Ethernet
No help text is available fo r this menu.
Important !
If communications software (front end, terminal) is used, the communication settings
must match those for the Ethernet communications software.