Operating instructions

G3 Series Malfunctions
Error messages
6-9
000012,03,02-2009, jmu
6
Cause
Parameters are currently being edited on another operating unit. While this is
happening no data can be edited on a second operating unit
Solution
Wait until the editor is closed on the other operating unit. Attempt another time.
0x0000FB01 This user level requires a password.
A passwor d must be entered in order to enter the requested user level. Use the parameter password. The parameter editor is opened direct ly when you press information.
260
Cause
If the user level has been changed and a password is needed for this purpose then
the entry of the password is displayed with this message.
0x0000FC01 Access denied. Incorrect user code.
261
Cause
An incorrect user code was transmitted. Access has been denied.
0x0000FF04 The version of the saved database that has to be loaded is not compatible with the
current software.
264
Contact service
0x00011501 System is already in the required operating status.
No help available
286
Cause
System is already in the initialisation status
0x00011602 It is not possible to change the operating status.
The sys tem cannot change the opera ting stat us. There are status changes which are not permitt ed, e.g. from th e status 'ONLINE' to the status 'Initialisati on'.
287
Cause
It is not possible to change directly from the current status to the required status. For
example, it is not possible to change directly between the operating status ONLINE
and the initialisation status.
Solution
First, set the correct status.
0x00011702 Stop factor overwritten
288
Contact service
0x00011B03 An instruction could not be restored. Inform the manufacturer of this error.
292
Contact service
0x00011C04 Err. during init of X & Y axes.
Curve axis: %0s
Init state: %1s
An error occurred during t he initialisation o f the X and Y axis .
0x00011E03 Incorrect key allocation to the axes. Change configuration or use new software ver-
sion.
295