Operating instructions

Malfunctions G3 Series
Error messages
6-14
000012,03,02-2009, jmu
6
0x00015E01 Press the ONLINE key to repeat the output.
The last plotte r data was rel oaded. Pressin g the ONLINE key will mean that they are processed again.
363
Cause
Message to the user after the replot command. The user will be prompted to press
the Online key so that the replot can be carried out.
0x00016002 Curve vector length too short.
Curve leng th smaller than the look ahead length .
365
Contact service
0x00016202 Error when setting a sub-instruction.
An error occurred when setting a sub-instruction. Please inform the manufact urer.
367
Contact service
0x00016402 Incorrect serial interface parameter.
Check serial interface parameters.
369
Contact service
0x00016502 Incorrect Z axis parameter.
Check the Z axis parameters.
370
Contact service
0x00016602 Table number not in the area.
The current tabl e number is n ot in the area o f 0 to 99999.
371
Contact service
0x00016702 Table ID not in the area.
Set a vali d table ID.
372
Contact service
0x00016901 No basic settings available.
Set the table type and serial num ber.
374
Contact service
0x00016A01 Different versions of the settings.
Check set tings and s ave.
375
Contact service
0x00016B03 No HAL file found.
No help av ailable
376
Contact service
0x00016C01 The database was empty during start-up.
Save the e ntire database o nce.
377
Contact service
0x00016D02 No response from the module carriage.
Check the connection to the Y board.
378
Contact service
0x00016E03 Communication lost.
Check CAN connection to the operating unit.
379
Contact service
0x00016F01 HAL file successfully transferred.
Restart plotter.
No help av ailable
380
Contact service