Operating instructions

G3 Series Malfunctions
Error messages
6-17
000012,03,02-2009, jmu
6
0x00018D03 Tool overcurrent.
Overcurrent d etected on the to ol insert.
412
Cause
An overcurrent error occurred in the tool.
Solution
Pull the tool out of the material.
0x00018E03 Excess module temperature.
The modu le insert has got t oo hot.
413
Cause
The module is too hot.
Solution
Wait until the module has cooled down.
0x00019003 Communication between the panel and MC interrupted.
No help available
415
Contact service
0x00019103 Unknown module position.
Module positio n is not RELEASE, PARK, UP or DOW N. Correct the module position.
416
Contact service
0x00019302 This tool is still inserted in another module.
No help available
418
Contact service
0x00019402 Incorrect logger parameter.
Index = %0s!
No help available
419
Contact service
0x00019503 Clipping area is too small.
The clip ping area must be lar ger.
420
Cause
The clipping window was defined to be too small. It is not possible to carry out a
calculation.
0x00019702 Errors are still present.
All error s must be r emedied b efore the action can be carri ed out.
422
Contact service
0x00019801 Command %0s not carried out.
No help available
423
Contact service
0x00019904 Error during the system start-up. Restart the cutter.
Error no.: %0s
Error index: %1s
Error during th e initialisati on of the axes.
424
Contact service
0x00019A01 No travel movement is possible with the current module.
A virtual mo dule is active. Change to a valid module .
426