Operating instructions

Malfunctions G3 Series
Error messages
6-18
000012,03,02-2009, jmu
6
Cause
A virtual module is selected. It is not possible to move the axes with this module. The
virtual module is selected if a select pen is set on a module which is not available on
the active head.
Solution
Select valid module.
0x00019C03 Terminator characters not permitted.
The following characters are n ot permitted:sign = 17 X ONsign = 19 X OFFsign = 27 ESCsign = 64 '@'
428
Contact service
0x00019D02 Unknown machine ID.
The reques ted machine ID i s not available.
429
Contact service
0x00019E03 Flash already occupied.
No help av ailable
430
Contact service
0x00019F02 Error in a S19 row.
Error foun d in S19 file duri ng the firm ware update.
431
Contact service
0x0001A202 Feeding clamp not configured.
Activate feeding clamps in the p aging element m enu.
434
Cause
The feeding clamp is not installed/has not been activated.
Solution
Activate the feeding clamp in the feeding clamps menu.
0x0001A303 Feed initialisation error.
The sensor has not recognised any material.
435
Cause
An error occurred during the initialisation of the page feed process.
Solution
Check paging configuration.
0x0001A403 No material.
No help av ailable
436
Contact service
0x0001A603 Incorrect number of parameters in the feed command.
No help av ailable
438
Cause
Incorrect number of parameters for a paging function.
Solution
Correct command
0x0001A703 HAL: Unknown Altera function.
HAL file line no.: %0s