Operating instructions

Malfunctions G3 Series
Error messages
6-20
000012,03,02-2009, jmu
6
Cause
An attempt was made to use a router converter on two different tools at the same
time.
0x0001B303 Timeout when starting the router.
No help av ailable
451
Cause
The router could not reach its speed after being switched on.
0x0001B403 Router overloaded. Could not keep up the specified speed.
No help av ailable
452
Cause
The router has deviated too much from the target speed and has therefore been
stopped.
Solution
It may be the case that the routing speed has not been adjusted to the material.
0x0001B503 Router overloaded.
The current in the converter is too high.
No help av ailable
453
Cause
The router is overloaded. There is too much current flowing.
Solution
It may be the case that the routing speed has not been adjusted to the material.
0x0001B603 Different table reference point.
The table refer ence point mus t be recalculate d or left as it is.
454
Cause
A module was removed or added. In this process it was determined that the same
zero point can no longer be used.
0x0001B702 Dummy module active.
No help av ailable
455
Contact service
0x0001B801 Light barriers not active.
No help av ailable
456
Contact service
0x0001B903 Setup object not available.
Inform your ser vice partner. Th is is a programmi ng error.
457
Contact service
0x0001BA03 No tool object available.
Inform your ser vice partner; this is a pr ogramming err or.
458
Contact service
0x0001BB04 Virtual HAL object is already being used by another application.
eHALIdent: %0s
No help av ailable
459
Contact service