Operating instructions

G3 Series Malfunctions
Error messages
6-21
000012,03,02-2009, jmu
6
0x0001BD03 Hardware not available.
It has been d etermined that an attempt was m ade to access un available h ardware.
461
Contact service
0x0001BE03 Error in the user data command.
Cmd:%1s
Tsk:%2s
Check the content and the size of the user data.
462
Contact service
0x0001BF02 AKI not available.
Install and configure automatic initialisatio n tool.
463
Cause
AKI not available
Solution
Connect AKI and activate. Warning: The plug for the option board can be inserted
incorrectly in spite of the coding. Check the plug. Is the correct HAL file loaded?
0x0001C003 AKI sensor error.
Check the connection to the automatic initialisation tool; the light barrier may be defect ive.
465
Contact service
0x0001C102 Cutter database is corrupt. The data has been lost. The standard values were used.
No help available
466
Contact service
0x0001C203 Automatic initialisation is not possible with this tool.
Activate auto matic initialisati on tool on the to ol or choose another tool.
467
Cause
The automatic initialisation tool cannot be used on this tool.
Solution
This setting can be adjusted by the user. However, the default setting is supplied by
the tool.
0x0001C303 Maximum position reached.
No tool or sens or defective.
468
Cause
The travel range for the initialisation of the tool has been reached.
• No tool in the module
• Sensor defective.
0x0001C403 AKI unexpected status.
Inform the man ufacturer.
469
Contact service
0x0001C502 The %2s command is only permitted in the service user level.
No help available
470
Contact service
0x0001C602 This type of AKI position indicator is not supported.
Change positi on indicator to a tool or to the laser pointe r.
471
Contact service