Operating instructions

Malfunctions G3 Series
Error messages
6-22
000012,03,02-2009, jmu
6
0x0001C704 Parameter transfer complete. Restart the cutter in order to use the new parameters.
No help av ailable
0x0001C803 AKI in the park station.
Remove automati c initialisati on tool from the p ark station.
473
Cause
The AKI must not be in the park station during use. An attempt was made to carry
out tool initialisation even though the AKI is still in the park station.
Solution
Position AKI on the table
0x0001C903 AKI not in the park station.
The action to be carried out demands that the automatic initialisation tool is in the p ark statio n.
474
Cause
The action to be carried out (e.g. start-up) demands that the AKI is in the park station
Solution
Position AKI in the park station. Restart cutter.
0x0001CA04 Errors occurred during the parameter transmission. Nothing has been saved. Restart
the cutter in order to restore the old status.
Errors occurre d during the param eter transmis sion. The parame ters which were transferred correctly have no t yet been saved. The cutter mus t be resta rted in ord er to restore the old status .
475
Contact service
0x0001CB02 Automatic initialisation tool blocked for tool.
Automatic initialisation tool is blocked for the current tool.
476
Cause
The initialisation of the tool is blocked via the automatic initialisation tool.
Solution
Change the corresponding tool parameter AKI_possible.
0x0001CD03 Unexpected programming error.
Programming error. Please inform yo ur service partner.
478
Contact service
0x0001CE03 Invalid controller parameter.
Programmin g error. Inform your ser vice partn er.
479
Contact service
0x0001CF03 Error in the message parameter.
Cmd: %0s
Task: %1s
No help av ailable
480
Contact service
0x0001D003 Incorrect axis sequence.
No help av ailable
481
Contact service
0x0001D204 The power unit is too hot. The electronics may be damaged.
It may be the ca se that the pow er unit has poo r cooling. The fi lters may be contaminated.
483