Operating instructions

G3 Series Malfunctions
Error messages
6-23
000012,03,02-2009, jmu
6
Cause
The power unit is too hot, the cutter must be switched off and the problem in the
power unit must be remedied.
Solution
It may be the case that the ventilation in the power unit is not correct. Check for dirt
and clean if necessary.
0x0001D303 Unauth. mod. change
This can lead to hazardous situations.
Always use "Start module change" to assemble or dismantle modules.
No help available
484
Cause
A module was assembled or dismantled without the system being notified. This can
lead to a hazardous situation.
0x0001D402 ACBug Controller data lost.
No help available
485
Contact service
0x0001D503 Too many parameters selected for the ACBug output.
No help available
486
Contact service
0x0001D604 Flash access error.
Error number: %0s
No help available
494
Contact service
0x0001D701 Change to module %0s. Module carriage moves.
No help available
495
Cause
Information for the users that there is an automatic change to another module and
that the module carriage is moving.
0x0001D803 Mod. supply (VMOT) could not be switched on.
The time was exceeded.
No help available
496
Contact service
0x0001D903 Mod. amplification (AMP) could not be switched on.
Timeout.
No help available
497
Contact service
0x0001DA03 The module backup could not be opened.
No help available
498
Contact service
0x0001DB03 Option board not found.
No help available
499
Contact service
0x0001DC01 This slot cannot be used. (Already occupied or not available.)
This OptAnt Board is already being used by another application or the corresponding option board is not available.
500
Contact service