Operating instructions

Malfunctions G3 Series
Error messages
6-24
000012,03,02-2009, jmu
6
0x0001DE03 The Z link synchronisation has not come about.
No help av ailable
502
Contact service
0x0001DF04 The sequencer task has not started.
The Altera is therefore not ready.
No help av ailable
503
Contact service
0x0001E002 Unstable controller parameters.
Axis: %0s
Error:%1s
i params
0x0001 neg high param
0x0002 pos low param
0x0004 high smaller than low
v Params0x0100
0x0200
0x0400
No help av ailable
504
Contact service
0x0001E101 Vacuum generator error
No help av ailable
505
Contact service
0x0001E201 Vacuum generator not ready.
No help av ailable
506
Contact service
0x0001E303 Timeout during switching of the tool connection.
No help av ailable
507
Contact service
0x0001E401 Pump switch-on error.
No help av ailable
508
Contact service
0x0001E801 Pump switch-off error.
No help av ailable
512
Contact service
0x0001E904 A status bit in the Z link has been occupied twice.
No help av ailable
513
Contact service
0x0001EA01 No pump or valve available to switch on.
No help av ailable
514
Contact service
0x0001EB01 HW must first be allocated to an option board.
No help av ailable
515
Contact service
0x0001EC02 Tool not inserted in conn. %0s.
It was determine d that the tool is not connect ed. The error occurs eve n when the error signals overcurrent and e xcess temperature are present when the tool is switched on.
516
Contact service
0x0001ED03 Excess temperature of the X axis motor.
No help av ailable
517