Operating instructions

Malfunctions G3 Series
Error messages
6-26
000012,03,02-2009, jmu
6
Contact service
0x0001F703 The speed requirement could not be reached.
No help av ailable
527
Cause
The speed requirement of the router was not reached.
0x0001F803 Altera ZERO pointer.
No help av ailable
528
Contact service
0x0001FA03 Error when writing data via Z link.
Index: %0s
No help av ailable
530
Contact service
0x0001FB03 Error when reading data via Z link.
Index: %0s
No help av ailable
531
Contact service
0x0001FC01 OptionBoard (Str1A) not available. The manual feed table was therefore deactivated.
No help av ailable
533
Contact service
0x0001FD04 Timeout in the sequencer.
Error: %0s
Last cmd: %1s
No help av ailable
534
Contact service
0x0001FE02 Err. in mod. data. Error in the parity test.
No help av ailable
535
Contact service
0x00020002 A mod. offset is outside the tolerance.
Module: %0s
Offset: %1s
The module must be checked. Mo dule: Corresponds to the module n umber Offset: 0 = X; 1 = Y; 2 = Z
537
Contact service
0x00020102 Err. during data inspection.
The data cannot be used.
No help av ailable
538
Contact service
0x00020204 Err. during Altera programming.
No help av ailable
539
Contact service
0x00020304 Short circuit detected.
Index: %0s
Index 0x01: Short circuit between 24 V and 24 V_NA.
543
Contact service
0x00020403 Cam. focus aid not locked.
Lock the focus aid onto t he front of the camera.
544