Operating instructions

G3 Series Malfunctions
Error messages
6-27
000012,03,02-2009, jmu
6
0x00020503 PWM control over-modulated.
The parameters must be adjusted.
No help available
545
Contact service
0x00020603 Aux drive %0s not ready.
No help available
546
Contact service
0x00020704 Comm to Y board interrupted.
No help available
547
Contact service
0x00020803 Overload detected on OptionBoard.
String no. = %0s.
Driver no. = %1s.
String no. : 1 -> Stri ng 1 A 2 -> Str ing 1 B 3 -> String 2 A 4 -> String 2 B 5 -> String 3 A 6 -> String 3 B
548
Contact service
0x00020903 Incompl HP-GL comm
Data may have been lost.
Command %2s is incorrect.
The HP-G L command has too few/too ma ny parameters. Data may also have been lost on the interfaces. Please check settings.
549
0x00021104 Fork light barrier err.
Axis: %0s
Status: %1s
A fork lik e barrier gives n otification of a defect Ax is: 0 : X-axis 1: Y-axis s tatus:
0: Permanent light 1: Unexpected status
558
Contact service
0x00021203 Incorrect axis index.
This is a programm ing error. Please in form the manufac turer.
559
Contact service
0x00021403 Rev transport with aux drive blocked.
No help available
561
0x00021503 Trans file not a plotter update.
No help available
562
Contact service
0x00021603 Trans file not a panel update.
No help available
563
Contact service
0x00021703 Trans file not YM board update.
No help available
564
Contact service
0x00021803 Trans file not a cam. update.
No help available
565
Contact service
0x00021903 Trans file not a mod. board update.
No help available
566
Contact service