Operating instructions

Malfunctions G3 Series
Error messages
6-28
000012,03,02-2009, jmu
6
0x00021A03 New mod. board FW does not match installed mod. type. installed: %2s
No help av ailable
567
Contact service
0x00021B03 Trans Altera file not recognised.
No help av ailable
568
Contact service
0x00021C03 No data for update.
No help av ailable
569
Contact service
0x00021E01 OptionBoard (Str1A) not available. Take-up/unwind units therefore deactivated.
No help av ailable
571
Contact service
0x00022401 Error during camera communication.
No help av ailable
585
0x00022503 In the case of PUM, a cylinder locks in the lower position.
The signa l for the u pper position ha s not act ivated.
586
0x00022601 Changes to the ethernet parameters will only become effective after the plotter is re-
started.
No help av ailable
587
0x00022703 The received HPGL command does not correspond to the syntax: %2s
No help av ailable
588
0x00022803 Universal board: Typing error.
No help av ailable
589
0x00022903 Universal board: Read error.
No help av ailable
590
0x00022A03 In the case of PUM, no cylinder has arrived in the lower position.
The signal for the lower position has not activated.
591
0x00022B03 Synchronisation problem on the UniBrd-SPI.
No help av ailable
592
0x00022C03 An error occurred on the universal board.
No help av ailable
593
0x00022D01 The start point is outside of the value range and will therefore be deactivated.
No help av ailable
594
0x00022E03 Negative feeds cannot occur with the universal unwind unit.
No help av ailable
595